57 of 285
Clarifier
The clarifier is used to finely tune the receiver on the selected channel to
compensate for received signals from other stations that are off frequency.
The receiver can be tuned in the clarifier mode in steps of 1Hz to frequencies up to
-1 kHz and +1 kHz of the assigned channel frequency, depending on programming.
(see note below)
to enter clarifier tune mode.
or tune clarifier up
or tune clarifier down
Note:- There are five clarifier ranges available, these ranges can be set either when
programming the transceiver or in the “RF Settings” section of the protected
menu.
Note:- The clarifier value is set to zero when the channel is changed or the
transceiver is turned off.
To Next Page
Loading...
