79 of 285
This screen shows the default Selcall self ids for OEM and International type
Selcall. INT1 is the default four digit ID for International or CCIR programmed
channels. INT2 is the default six digit ID for International or CCIR programmed
channels. OEM1 is the default four digit ID for OEM programmed channels. OEM2
is the default six digit ID for OEM programmed channels. If “N/A” is shown then that
particular ID has not been set as yet. In the screen below neither OEM Selcall self
id has been set.
This screen shows the battery voltage in receive, the battery voltage during the last
transmit cycle and the PA temperature.
Transceiver GPS coordinates are also shown if a GPS is fitted and has acquired
satellites.
If an internal modem is fitted then the internal modem status is displayed. The
status is either enabled or disabled.
To Next Page
