4-68 DGC-2020 BESTCOMSPlus Software 9400200990 Rev I
MTU MDEC
The MTU MDEC reports operating information to the DGC-2020 through the CAN interface when the
ECU is configured for MTU MDEC. Operating parameters and diagnostic information, if supported by the
MTU MDEC, are decoded and displayed on these screens.
MDEC Alarms
MDEC Pre-Alarms and MDEC Alarms are reported on this screen. Refer to Figure 4-72.
Figure 4-72. Metering, MDEC Alarms
MDEC Fault Codes
MDEC Fault Codes can be viewed and downloaded on this screen. Refer to Figure 4-73.
Figure 4-73. Metering, MDEC Fault Codes
www . ElectricalPartManuals . com
To Next Page
Loading...
