Baumuller b maXX 5500 - Page 125

Design and Operation
Instruction handbook b maXX BM5500, BM5600, BM5700
Document No.: 5.13008.10
125
of 314
4
BM5XXX-XXXX[Ryy]-XXXX-XXXX-XX-XXXX SAF-Module
0: no SAF module
BM5-O-SAF
A: -000-000-001 SAF module standard without parameter memory
B: -000-000-000 SAF module with parameter memory
C: -001-000-000 STO controllable via I/O, with parameter memory, 
without automatic restart
D: -001-000-002 STO controllable via I/O, with parameter memory, 
with automatic restart
E: -002-000-000 STO controllable via I/O and FSoE, with parameter 
memory, with daisy-chain inputs, without separated grounds,
with 12h encoder test
F: -002-001-000 STO controllable via I/O and FSoE, with parameter 
memory, without daisy-chain inputs, 
without separated grounds, with 12h encoder test
G: -003-000-000 STO controllable via I/O and FSoE, with parameter 
memory, with daisy-chain inputs, without separated grounds,
with 12h encoder test
H: -003-001-000 STO controllable via I/O and FSoE, with parameter 
memory, without daisy-chain inputs, 
without separated grounds, with 12h encoder test
I: -001-001-000 STO controllable via I/O, without parameter memory, 
with automatic restart, with short-circuit test
K: -001-001-001 SS1 controllable via I/O (SS1 time is a fixed set value), 
without parameter memory, with automatic restart, 
with short-circuit test
BM5XXX-XXXX[Ryy]-XXXX-XXXX-XX-XXXX Power unit design
BM50XX, BM51XX
0: X1 inhibit input expects NO contact
1: X1 inhibit input expects NC contact
BM53XX
4: With motor brake, new grounding concept, PE screw terminals
5: Without motor brake, new grounding concept, PE screw terminals
BM55XX/BM56XX/BM57XX
6: Basic unit with ballast transistor U
DC
= 540 V
7: Basic unit with ballast transistor U
supply
=230 V ±10 %, U
DC
=310 V
8: Power module (only output sided inverter), U
DC
=540 V
9: Basic unit with ballast transistor, U
DC
=540 V short design
A: Basic unit without ballast transistor U
DC
= 540 V
B: Basic unit without ballast transistor U
supply
=230 V ±10 %, U
DC
=310 V
D: Basic unit without ballast transistor, U
DC
=540 V short design
E: Basic unit with ballast transistor U
DC
= 540 V, new heat sink 
F: Basic unit without ballast transistor U
DC
= 540 V, new heat sink
BM5XXX-XXXX[Ryy]-XXXX-XXXX-XX-XXXX Brake resistor option
R16: Brake resistor with 16 
R10: Brake resistor with 10 
R05: Brake resistor with 5 
R03: Brake resistor with 3 