Baumuller b maXX BM3400 Series - Page 129

Trouble shooting 8.5T
• OperatingError (Error in module operating system) P0202
Error
no.
Mea ning Reaction Troubleshooting
16 Not assigned — —
17 Software er ror (e.g. switch) PI Restart b maXX® BM3400
18 Error configuration time-slice
operating system
PI Restart b maXX® BM3400
19 Time slot duration error PI Restart b maXX® BM3400; After
repeated occurence contact
Baumüller.
20 No more memory left PI Restart b maXX® BM3400
21 Invalid error code PI Restart b maXX® BM3400
22 Invalid warning code P I Restart b maXX® BM3400
23 Not all required type plates could be
loaded
PI Contact Baumüller.
24 Error at writing on the target
parameter two-state c ontroller output
PI Correct the parameterization of the
two-state controller (only if existing)
25–31 Not assigned — —
• ProprogError (Error in module Proprop communication driver) P0203
Error
no.
Mea ning Reaction Troubleshooting
32 Timeout Proprog protocol — Restart b maXX® BM3400
33 Protocol error — Restart b maXX® BM3400
34 Incorrect module type — Contact Baumüller.
35 Too many data in the list or telegram — Contact Baumüller.
36 Not enough data in the list or telegram — Contact Baumüller.
37 Invalid operand — Contact Baumüller.
38 Invalid memory type — Contact Baumüller.
39 Invalid operand address (log. address) — Enter a valid address.
40 Value < Minimum value — Check the data set and c orrect the
value.
41 Value > Maximum value — Check the data set and correct the
value.
42 Parameter is read-only — Check the data set and adjust it.
Instrution Manual b maXX ® BM3400 129
Doument No.: 5.07013.03 from 206