BEECHCRAFT
Debonair
C33
Bonanza E33 and
f33
Section VII
Systems
Descripticm
DOORS,
WINDOWS
AND
EXITS
CABIN DOOR
The outside cabin door handle is spring loaded to fit into a
recess
in
the
door to create a flat aerodynamica!ly clean
surface.
To
open the
door
from
the
outside,
litt
the handle
from
its recess and pull
until
the door opens.
To
close the cabin door
from
the
inside, observe
that
the
door handle is
in
the unlocked position. In
this
position,
the
latch handle is free
to
move approximately one
inch
in
either
direction before engagement
of
the
locking
mechanism. Then grasp
the
door and
firmly
pull
the
door
closed. Rotate the door handle
fully
counterclockwise
into
the locked position.
When
the door is properly locked, the
door latch handle is free
to
move approximately one
inch
in
either
direction.
NOTE
When
checking
the
door
latch handle,
do
not
move
it
far
enough
to engage the door latch
release
mechanism.
Press
firmly
outward
at
the
top rear
corner
of
the door.
lf
any
movement
of
the
door
is
detected, completely open the
door and
close again
following
the
above instructions.
To open the door
from
the
inside, depress the lock
button
and rotate the handle clockwise.
OPENABLE CABIN WINDOWS (Optional E33 and F33)
To
open
window:
Release latch
front
of
bar,
pull
bar
at
the bottom
of
the
window
out
and upward.
Window
will
open approximately
two
inches.
August
1982
7-19
To Next Page
Loading...
