Beechcraft Bonanza E33 - Cleaning; Exterior Painted Surfaces

BEECHCRAFT
Debonair C33
Bommza E33 and f33
Section VIII
Handling, Serv - Maint
WARNING
To be safe, treat the magnetos as hot
whenever a switch lead is disconnected at any
point; they do
not have an internal automatic
grounding device. The magnetos can be
grounded by replacing the
switch lead at the
noise
filter capacitor with a wlre which is
grounded to the engine case. Otherwise, all
spark plug leads should be disconnected or the
cable
outlet plate on the rear of the magneto
should be removed.
ClEANING
EXTERIOR PAINTED SURFACES
WARNING
Do not expose control surface trim tab hinge
lines and
their pushrod systems to the direct
stream or Spray
of high-pressure, soap-and-
water washing equipment. Fluid dispensed at
high pressure could remove the protective
lubri-
cant, allowing moisture from heavy or pro-
longed rain to collect at hinge lines. and then to
freeze at low ternpera1tures. After high-
pressure or hand washing, and at each periodic
inspection, lubricate
trim tab hinge lines and
trim tab pushrod end fittings
(Brayco 300 per Federal Sp;ecification W-L-
800 preferred). See Consumable Materials.
Revised: March 1983
8-29
1