●Exhaust the air in the radiator according to the following steps:
○Start the engine (the radiator cap has been removed) and make the
engine run at the speed of 3000 RPM to 4000 RPM until no bubble
can be seen in the coolant [A].
○Lightly pat the radiator hose to discharge the bubbles in the hose.
○Shut off the engine and add the coolant until the level reaches the
filler neck of radiator.
●Tighten the radiator cap.
●Start the engine and make it become hot thoroughly until the
radiator fan runs and then turn off the engine.
●After the engine is cooled, check the level of coolant in the reserve
tank.
★If the coolant level is lower than the lower fluid level line, add
coolant until the level reaches the highest fluid level line.
Note
Do not exceed the highest level line when adding the coolant.
2-56
To Next Page
