Bernette b79 - Embroidery Settings Configuration

Setup Program
46
2019-02 EN 5020079.00A.04
Programming the button «Quick reverse»
It can be chosen either «Reverse sewing» or «Backstepping».
> Touch the icon «Setup Program».
> Touch the icon «Sewing settings».
> Touch the icon «Program buttons and icons».Touch the switch again to deactivate the presser foot raised
to hovering position with needle stop down.
> Touch the icon «Program Quick reverse».
> Touch the icon «Backstepping» to activate backstepping.
> Touch the icon «Backstepping» to activate backstepping.
Programming the foot control individually
When the icon «Needle up/down» is activated, the needle is raised or lowered via a back kick on the foot
control. Alternatively, the presser foot can be positioned, the thread can be cut and the automatic securing
can be programmed.
> Touch the icon «Setup Program».
> Touch the icon «Sewing settings».
> Touch the icon «Program the foot control».
– The icon «Needle up/down» is activated by default.
– The back kick on the foot control raises or lowers the needle.
51
> Touch the icon «Program the back kick» to program the back kick.
> Touch the icon «Securing» to activate the automatic securing via the back kick.
> Touch the icons «-» or «+» to program the number of securing stitches.
> Touch the icon «Securing» again to deactivate the automatic securing via the back kick.
51
> Touch the icon «Cut thread» to activate the automatic thread cut via the back kick.
> Touch the icon «Cut thread» again to deactivate the thread cut via a back kick on the foot control.