Bernette b79 - Error Messages

Attachment
142
2019-02 EN 5020079.00A.04
17.3 Error messages
Message on the display Cause Repair
???
The stitch does not exist. > Check the entry and enter the new number.
!!!
Selection of the stitch pattern not
possible in the Combi mode.
> Check the entry and enter the new number.
The stitch cannot be used in
Combi mode.
> Select other stitches.
Embroidery module has to be
removed.
> Push the release button and pull the embroidery module
carefully to the left.
The embroidery module has to be
attached.
> Carefully slide the module from left to right into the
module connection of the machine.
The selected needle and stitch
plate cannot be used in
combination.
> Check if the selection of needle and stitch plate is
correct.
> Change the needle and select the correct needle in the
User Interface.
> Change the stitch plate and select the correct stitch
plate in the User Interface.
The bobbin winder is activated. > Deactivate the bobbin winder.
The thread indicator is
deactivated.
> To activate both indicators, touch the icon «Confirm».
> To keep the indicators deactivated, touch the icon
«Cancel».