Bernette b79 - 13 Embroidering Preparation; Attaching the Module; Embroidery Foot; Attaching the Embroidery Foot

Embroidering preparation
106
2019-02 EN 5020079.00A.04
13 Embroidering preparation
13.1 Attaching the Module
NOTICE
Transporting the embroidery module
Damage to the embroidery module connection and machine.
> Remove the embroidery module before transporting the machine.
> Make sure that the module and the machine are placed on a stable, even surface.
> Make sure that there is enough space around to allow the unimpeded movement of the embroidery arm.
> Lift the embroidery module on the left.
> Carefully push the module from left to right into the embroidery module connection (1) of the machine.
1
> To remove, hold the embroidery module and press the release button (2), then slide left the embroidery
module out of the machine arm.
2
13.2 Embroidery foot
Attaching the embroidery foot
Mount the embroidery foot
> Raise the needle.
> Raise the presser foot and dual feed.
> Switch the machine off and disconnect it from the power supply system.