Practical stitches
80
2019-02 EN 5020079.00A.04
6.15 Sewing visible hems
The visible hem is especially suitable for elastic hems in jersey, cotton, wool, synthetic and mixed fibers.
> Attach the Embroidery foot (JK).
> Touch the icon «Practical stitches».
> Select Tricot stitch No. 14.
> Iron the hem and baste if necessary.
> Reduce the presser foot pressure if necessary.
> Sew the hem at the preferred depth on the right side.
> Trim the excess fabric from the wrong side.
6.16 Sewing basting stitches
When sewing basting stitches, it is recommended to use a fine darning thread. This is easier to remove. The
longest stitch possible is 5 mm. The recommended stitch length is 3.5 – 5 mm. The basting stitch is suitable
or sewing projects where a very long stitch length is required.
> Attach the Zigzag foot (DA).
> Touch the icon «Practical stitches».
> Select the Basting stitch No. 21.
> Select the stitch length.
> Pin the fabric layers at a right angle to basting direction to prevent the layers from slipping.
> Sew 3 – 4 securing stitches at the beginning and at the end.
6.17 Sew thick areas
> Attach the Zigzag foot (DA).
– The black button on the left side of the presser foot will lock the presser foot in a horizontal position if
you push it in before lowering the presser foot (1). This ensures even feeding at the beginning of a
seam and helps when sewing multiple layers of fabric such as sewing over seams when hemming
jeans.
> When you reach the point of an increased thickness, lower the needle and raise the presser foot.
> Press the toe of the foot and push in the black button, then lower the foot and continue sewing.
– The black button releases automatically after sewing few stitches.
To Next Page
Loading...
