Bernette b79 - Calibrating the Embroidery Hoop; Deactivating Securing Stitches

Setup Program
48
2019-02 EN 5020079.00A.04
Calibrating the embroidery hoop
The calibration of the embroidery hoop is the coordination of the needle to the center of the embroidery
hoop.
Prerequisite:
• The embroidery module is connected and the embroidery hoop with the appropriate embroidery
template is attached.
> Touch the icon «Setup Program».
> Touch the icon «Embroidery settings».
> Touch the icon «Calibrate the embroidery hoop».
– The machine recognizes the size of the attached embroidery hoop automatically and moves to the
center of the hoop.
> Center the needle via the arrow icons on the display and confirm.
Deactivating securing stitches
> «»Touch the icon «Setup Program».
> Touch the icon «Embroidery settings».
> Touch the icon «Securing stitches on/off».
> Touch the switch in the lower left corner of the display to deactivate the securing stitches.
– No securing stitches will be sewn and the bobbin thread needs to be brought up manually and held
when embroidering is started.
> Touch the switch again to activate the securing stitches.