Practical stitches
75
2019-02 EN 5020079.00A.04
> Touch the icon «Practical stitches».
> Select the reinforced Darning Program No. 23.
> Lower the presser foot over the center of the tear.
> Adjust the button holder on the buttonhole foot to the desired length. The size of one darning sequence
is variable.
– The maximum sewing length is 2.6 cm (1 inch) and the maximum sewing width is 7 mm (9/32 inch).
1 The length of sewing 3 Start
2 The width of sewing 4 Stop
> Position the fabric so that the needle is 2 mm (1/16 inch) in front of the area to be darned.
> Lower the presser foot.
When lowering the presser foot, do not push the front of the presser foot, otherwise the darning will not be
sewn in the correct size.
> Lead the upper thread down through the hole in the presser foot.
> Pull down the buttonhole lever as far as possible.
– The buttonhole lever is positioned behind the bracket on the buttonhole foot.
To Next Page
Loading...
