Bernina 790 PLUS - Reinforced Darning Program; Finishing Edges

Practical stitches
111
6.11 Reinforced Darning Program
The Darning Program No. 34 is particularly suitable for worn or damaged area in heavy or firm fabrics such as
denim or overalls.
> Attach the Reverse pattern foot No. 1C.
> Touch the icon «Practical stitches».
> Select the reinforced Darning Program No. 34.
6.12 Finishing edges
The Zig zag No. 2 is suitable for all materials. It can also be used for eleastic seams as well as for decorative
sewing. Use darning thread for fine materials. When sewing satin stitch it is recommended to select a dense,
short the zig zag with a stitch length of 0.5 – 0.7 mm. The satin stitch can be used for appliqué and for
embroidering.
Prerequisite:
• Theedgeofthefabricshouldlieflatandnotroll.
> Attach the Reverse pattern foot No. 1C.
> Touch the icon «Practical stitches».
> Select the Zig zag No. 2 or the Satin stitch No. 1354.
> Neither select too wide a stitch nor too long a stitch.
> Guide the edge of the fabric into the center of the presser foot, so that the needle goes into the fabric
on one side and over the edge into the air on the other side.