Bernina 790 PLUS - 9.5 Cord

Buttonholes
132
> Lower the buttonhole foot.
> Sew the buttonhole in the usual manner.
> Pull the cord through the buttonhole until the loop disappears in the bartack.
> Pull the ends of the cord through to the wrong side of the fabric (using a hand stitching-needle), knot or
secure with stitches.
Using cord with the Buttonhole foot No. 3C (optional accessory)
Prerequisite:
• TheButtonholefootNo.3C(optionalaccessory)isattachedandraised.
> Insert the needle at the beginning of the buttonhole.
> Hook the cord over the pin at the front of the buttonhole foot.
> Pull both cords ends under the buttonhole foot to the front and place each a cord into a groove of the
sole.
> Lower the buttonhole foot.