Bernina 790 PLUS - 11 BERNINA Stitch Regulator (BSR)

BERNINA Stitch Regulator (BSR)
145
11.5 Sewing preparations for quilting
Attach the BSR presser foot
NOTICE
The lens of the BSR presser foot is dirty
Themachinedoesn'trecognizetheBSRpresserfoot.
> Clean the lens with a soft, slightly damp cloth.
> Change the presser foot.
> Insert the cable of the BSR foot into the connection (1).
1
> Switch the machine on.
– The BSR display opens and the BSR 1 mode is activated.
Changing the presser foot sole
NOTICE
The lens of the BSR presser foot is dirty
Themachinedoesn'trecognizetheBSRpresserfoot.
> Clean the lens with a soft, slightly damp cloth.
The basic stitch length is 2 mm. When sewing small shapes and stippling it is recommended to shorten the
stitch length to 1 – 1.5 mm.
> Raise the needle.
> Raise the presser foot.
> Switch the machine off and disconnect it from the power supply system.
> Remove the presser foot (see page 43).
> Press both push buttons at the BSR foot against each other.
> Pull the presser foot sole out of the guide downwards.
> Insert the new presser foot sole into the guide and push upwards until it clicks into place.
> Attach the BSR presser foot (see page 145).