Bernina 790 PLUS - Altering the Stitch Density; Checking the Size and the Position of the Embroidery Motif

Creative embroidering
172
> Touch the icon «Change the stitch type».
> Touch the switch in the upper section of the display (1) to change the satin stitch to the step stitch.
> Adjust the desired stitch length (2) with the icons «-» or «+».
1
2
Altering the stitch density
If the satin stitches are embroidered too densely, the stitch density can be adjusted.
> Select an embroidery motif.
> Touch the icon «i»-Dialog.
> Touch the icon «Change the stitch type».
> Adjust the desired stitch density (1) with the icons «-» or «+».
1
Checking the size and the position of the embroidery motif
It can be checked whether or not the embroidery motif matches the designated position/location on the
fabric. Points which are beyond the embroidery hoop are not traveled to.
> Select an embroidery motif.
> Touch the icon «i»-Dialog.
> Touch the icon «Check embroidery motif size».
– The embroidery hoop travels all the way until the needle is at the position as it is indicated in the
display.
> Touch the icon «Corner top left» to select the top left corner of the embroidery motif.
– The embroidery hoop travels all the way until the needle is at the position as it is indicated in the
display.
check