Sewing preparation
43
2.8 Presser foot
Adjusting the presser position via the knee lifter of the Free Hand System
> Adjust the sitting height so that the knee lifter can be operated with the knee.
> Push the knee lifter with the knee to the right to raise the presser foot.
– Simultaneously the feed dog is lowered and the thread tension is released.
> Release the knee lifter slowly to lower the presser foot.
Adjusting the presser foot position via the button «Presser foot up/down»
> Push the button «Presser foot up/down» to raise the presser foot.
> Push the button «Presser foot up/down» again to lower the presser foot.
Changing the presser foot
> Raise the needle.
> Raise the presser foot.
> Switch the machine off and disconnect it from the power supply system.
> Push the clamping lever up.
> Remove the presser foot.
> Guide the new presser foot upwards over the cone.
> Press the clamping lever down.
Selecting the presser foot in the user interface
After the presser foot has been changed, it can be checked whether or not the presser foot is suitable for the
selected stitch pattern. In addition to that, alternative presser feet are displayed which are available for the
currently selected stitch pattern.
> Switch the machine on.
> Select a stitch pattern.
> Touch the icon «Presser foot display/Presser foot selection».
To Next Page
Loading...
