Chapter 6 Error Messages
Mini-Switch LB 471
Chapter 6. Error Messages
The device is checked for possible errors during operation and up-
on turning on of the supply voltage.
We distinguish between error messages and warnings:
Reaction in case of an „Err“ error message:
Code 10 shows "Err" and a two-digit number for the type of
error
Error LED lights up
Error relay signals alarm
Measurement goes to halt
Message is stored in error log
Reaction in case of a minor error “!!“:
"!!" appears on display
Measurement continues to run (stays in the RUN mode).
Minor errors will be indicated only when the parameters in code 42
through 48 (can only be set in the professional mode) have been
set accordingly.
The following table shows an overview of all error messages, their
possible causes and the action to be taken to eliminate the error.
To Next Page
Loading...
