Chapter 6 Water Cooling
Mini-Switch LB 471
6.1 Subsequent Installation of Water
Cooling (Option)
If you are working with the NaI detectors LB 4401, LB 5401 or GM
detectors, you may install a water cooling subsequently. See tech-
nical drawings on pages 121 and 122.
Preparation
You need clamps with a large diameter (90 mm) in order to fix the
detector later at its position again. These clamps have to be or-
dered separately in addition to the water cooling. If you are using
a detector holder instead of the clamps, you only have to remove
the plastic ring. See technical drawings on pages 123 and 124.
Depending on the type of detector, a different type of water cool-
ing may be needed. The assembly instructions apply to the follow-
ing detector types:
NaI detector with collimator
NaI detector without collimator
GM detector
To Next Page
Loading...