BK Precision XLN3640 - Page 72

65
:MODE <OFF/0,PARALLEL/1,SERIES/2|? >
set or return parallel/series mode
:TYPE <MASTER/0,SLAVEA/1,SLAVEB/2,SLAVEC/3|?>
set or return master/slave setting
[SOURce] Source Subsystem
:CURRent <NRf | ? > set or return current level:0-40/0-24A
:PROTection <Boolean | ? >
set or return over-current state
:LEVel <NRf | ? > set or return over-current level
:VOLTage <NRf | ? > set or return voltage level:0-36/0-60V
:PROTection <Boolean | ? >
set or return over-voltage state
:LEVel <NRf | ? > set or return over-voltage level
SYStem System Subsystem
:BEEP <Boolean | ? > set or return BEEP state
:E5V <Boolean | ? > enable or disable extra 5V output
:ERRor? return system error
:EXTernal<OFF/0,VOLT/1,RES/2 | ? >
set or return external state
:GPIB
:ADDRess <NR1 | ? > set or return GPIB address (1-30)
:IP
:ADDRess <NR1.NR1.NR1.NR1 | ? >
set or return IP address
:CONFig <STATic/0? >
set or return IP config mode
:KEY