234
1. 8 7 7. 8 7 7. 2 2 6 9 BLACKBOX.COM
NEED HELP?
LE AVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.8 7 7. 8 7 7. 2 26 9
CHAPTER 5: DIAGNOSTICS
64 bytes from ::10.10.132.20: icmp_seq=2, time=0ms
64 bytes from ::10.10.132.20: icmp_seq=3, time=0ms
64 bytes from ::10.10.132.20: icmp_seq=4, time=0ms
Sent 5 packets, received 5 OK, 0 bad
5.2 PING6
This section explains how to issue ICMPv6 PING packets to troubleshoot IPv6 connectivity issues.
WEB INTERFACE
To configure an ICMPv6 PING Configuration in the web interface:
1. Specify ICMPv6 PING IP Address.
2. Specify ICMPv6 PING Size.
3. Click Start.
FIGURE 5-2. ICMP6 PING SCREEN
Parameter description:
IP Address: The destination IP Address with IPv6
Ping Length: The payload size of the ICMP packet. Values range from 2 bytes to 1452 bytes.
Ping Count: The count of the ICMP packet. Values range from 1 time to 60 times.
Ping Interval: The interval of the ICMP packet. Values range from 0 second to 30 seconds.
Egress Interface (Only for IPv6): The VLAN ID (VID) of the specific egress IPv6 interface to which the ICMP packet goes. The given
VID ranges from 1 to 4094 and will be effective only when the corresponding IPv6 interface is valid. When the egress interface is not
given, PING6 finds the best match interface for destination. Do not specify an egress interface for a loopback address. Do specify
egress interface for a link-local or multicast address.
Start: Click the “Start” button, then the switch will start to ping the device using ICMPv6 packet size that you set on the switch.
After you press Start, 5 ICMPv6 packets are transmitted, and the sequence number and roundtrip time are displayed when the
switch receives a reply. The page refreshes automatically until responses to all packets are received, or until a timeout occurs.
PING server 10.10.132.20
64 bytes from 10.10.132.20: icmp_seq=0, time=0ms
To Next Page
Loading...
