26
1. 8 7 7. 8 7 7. 2 2 6 9 BLACKBOX.COM
NEED HELP?
LE AVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.8 7 7. 8 7 7. 2 26 9
CHAPTER 3: SYSTEM CONFIGURATION
On the other hand, if you want to disable an existing VLAN range, follow these steps:
1.Press “ADD VLAN Range” to add a new VLAN range.
2. input the VLAN range that you want to disable.
3. Choose Mode to be Disabled.
4. Press Apply to apply the change.
Then, you will see the disabled VLAN range is removed from the DHCP Server mode configuration page.
Mode: Indicates the operation mode per VLAN. Possible modes are:
- Enabled: Enable DHCP server per VLAN.
- Disabled: Disable DHCP server pre VLAN.
Buttons:
- Add VLAN Range - Click to add a new VLAN range.
- Apply – Click to save changes.
- Reset - Click to undo any changes made locally and revert to previously saved values.
3.4.1.2 EXCLUDED IP
This page configures excluded IP addresses. A DHCP server will not allocate these excluded IP addresses to a DHCP client.
WEB INTERFACE
To configure a DHCP server excluded IP in the web interface:
1. Click Configuration, DHCP, Server, Excluded IP.
2. Click Add IP Range, then you can create a new IP Range on the switch.
3. Click Apply.
FIGURE 3-11. DHCP SERVER EXCLUDED IP SCREEN
To Next Page
Loading...
