93
1. 8 7 7. 8 7 7. 2 2 6 9 BLACKBOX.COM
NEED HELP?
LE AVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.8 7 7. 8 7 7. 2 26 9
Reset – Click to undo any changes made locally and revert to previously saved values.
- Refresh – Refreshes the displayed table starting from the input fields.
<< – Updates the table starting from the first entry in the IPMC Profile Address Configuration.
>> – Updates the table, starting with the entry after the last entry currently displayed.
3.10 M V R
The MVR feature enables multicast traffic forwarding on the Multicast VLAN. In a multicast television application, a PC or a
television with a set-top box can receive the multicast stream. Multiple set-top boxes or PCs can be connected to one subscriber
port, which is a switch port configured as an MVR receiver port. When a subscriber selects a channel, the set-top box or PC sends
an IGMP join message to Switch A to join the appropriate multicast. Uplink ports that send and receive multicast data to and from
the multicast VLAN are called MVR source ports.
WEB INTERFACE
To configure the MVR Configuration in the web interface:
1. Click Configuration, MVR, Configuration.
2. Scroll the MVR mode to enable or disable and Scroll to set all parameters.
3. Click save to save the setting.
4. To cancel the setting, click the Reset button. It will revert to previously saved values.
FIGURE 3-57. MVR CONFIGURATION SCREEN
CHAPTER 3: SYSTEM CONFIGURATION
To Next Page
Loading...
