235
1. 8 7 7. 8 7 7. 2 2 6 9 BLACKBOX.COM
NEED HELP?
LE AVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.8 7 7. 8 7 7. 2 26 9
64 bytes from 10.10.132.20: icmp_seq=1, time=0ms
64 bytes from 10.10.132.20: icmp_seq=2, time=0ms
64 bytes from 10.10.132.20: icmp_seq=3, time=0ms
64 bytes from 10.10.132.20: icmp_seq=4, time=0ms
Sent 5 packets, received 5 OK, 0 bad
You can configure the properties of the issued ICMP packets.
5.3 VERIPHY
This section explains how to run the VeriPHY Cable Diagnostics. Press to run the diagnostics. This will take approximately 5
seconds. If all ports are selected, this can take approximately 15 seconds. When completed, the page refreshes automatically, and
you can view the cable diagnostics results in the cable status table.
NOTE: VeriPHY is only accurate for cables of length 7–140 meters.10 and 100 Mbps ports will be linked down while running
VeriPHY. Running VeriPHY on a 10 or 100 Mbps management port will cause the switch to stop responding until VeriPHY is
complete.
WEB INTERFACE
To configure a VeriPHY Cable Diagnostics Configuration in the web interface:
1. Specify the Port you want to check.
2. Click Start.
FIGURE 5-3. VERIPHY SCREEN
Parameter description:
Port: The port for which you are requesting VeriPHY Cable Diagnostics.
Cable Status:
- Port: Port number.
CHAPTER 5: DIAGNOSTICS
To Next Page
Loading...
