92
1. 8 7 7. 8 7 7. 2 2 6 9 BLACKBOX.COM
NEED HELP?
LE AVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.8 7 7. 8 7 7. 2 26 9
• Buttons:
- Add Last Rule – Click to add a new rule in the end of the specific profile’s rule list. Specify the address entry and configure the new
entry. Click “Commit.”
- Commit – Click to commit rule changes for the designated profile.
- Reset – Click to undo any changes made locally and revert to previously saved values.
3.9.2 ADDRESS ENTRY
This page provides address range settings used in the IPMC profile.
The address entry is used to specify the address range that will be associated with the IPMC Profile. You can create at maximum 128
address entries in the system.
WEB INTERFACE
You can configure the IPMC Profile Address Configuration in the web interface.
FIGURE 3-56. IPMC PROFILE ADDRESS CONFIGURATION SCREEN
Parameter description:
Delete: Check to delete the entry. The designated entry will be deleted during the next save.
Entry Name: The name used for indexing the address entry table. Each entry has a unique name composed of at maximum 16
alphabetic and numeric characters. At least one alphabetic character must be present.
Start Address: The starting IPv4/IPv6 Multicast Group Address that will be used as an address range.
End Address: The ending IPv4/IPv6 Multicast Group Address that will be used as an address range.
Buttons:
- Add New Address (Range) Entry – Click to add a new address range. Specify the name and configure the addresses. Click “Save.”
- Apply – Click to save changes.
CHAPTER 3: SYSTEM CONFIGURATION
To Next Page
Loading...
