106
After the Check-in process has been stopped, all Normal station calls
resume as normal calls to the Admin Station, and the Check-in pro-
cess Status becomes Idle.
6.1.3 Resetting the Check-In Process
During either an active or idle Check-In process, you can clear all sta-
tion check-in statuses and allow all Normal calls to resume as normal
calls to the Admin Station by selecting the Reset button on the Sta-
tion Check-in view.
6.1.4 Using Spy Mode
You can use Spy Mode to listen to a station as long as Privacy Mode
is not enabled and the station device allows two-way transmission.
This feature adds another step toward verifying that the room’s occu-
pants are safe.
To activate Spy Mode:
Step 1 If not already on your dashboard, select Dashboard
from the navigation bar.
Step 2 Under Calling/Paging, select Manage Check-In.
Step 3 On the Manage Check-In page, select the Listen In icon
for the station you want to monitor.
Step 4 When the dial pad appears, dial 978.
Figure 6-4, Listen In, or Spy Mode, Button
Note: Spy Mode monitoring cannot be used on a station that has been set to
Privacy Mode.
To Next Page
Loading...
Need help?
General