Bosch D9412GV2 - S## Defer Status; S## Defer Test; S## Hourly Report

D9412GV2/D7412GV2 | Program Entry Guide | 5.0 RADXSKED EN | 111
Bosch Security Systems | 5/05 | F001U003636B
Default: Blank
Selection: 1 to 11, 13 to 24, 28, 29
S## Defer Test
Yes
Defer the Test
Report.
Default: No
Selection: Yes or No
Enable sked to defer the Test
Report
No
Send the Test
Report on schedule.
S## Hourly Report
Yes
Send the Test
Report every hour.
9
Test Report: This function emulates
the Send Report? keypad function.
This function generates a Test Report
only from Area 1 but contains panel-
wide status information. The report is
sent to the phone(s) programmed for
Test and Status Reports in Section 2.3.8
Dialing Attempts onpage 14.
If
Expand Test Prt in Phone
parameters is programmed as Yes, the
Test Report also includes all off-
normal states for events listed in
Diagnostic Reports and Test Reports
(refer to Section 2.3.8 Dialing Attempts
on page 14).
The Test Report can be deferred if any
other report was sent since the last Test
Report. To defer the Test Report,
program
S## Defer Test .
The Test Report can be sent every
hour beginning at the time scheduled
in
S## Time . To send a Test Report
every hour, program
S## Hourly Rpt .
Default: No
Selection: Yes or No
Select Yes to send the Test
Report every hour.
No
Send the Test
Report only as
scheduled.
S## Defer Status
Yes
Defer the Status
Report.
10
Status Report: This function generates
a Status Report for each area that is
enabled. The report is sent to the
phone(s) programmed for Test and
Status Reports in Routing.
The Status Report can be deferred if
any other report was sent since the last
Status Report. To defer the Status
Report, program
S## Defer Status .
Default: No
Selection: Yes or No
Enable sked to defer the Status
Report.
No
Send the Status
Report on schedule.