D9412GV2/D7412GV2 | Program Entry Guide | 2.0 GV2MAIN EN | 35
Bosch Security Systems | 5/05 | F001U003636B
Table 22: Verify Time
Verification Point
Activiation
Verify Time/Reset
Sensors
Power removed,
ignore activity
60 second
Confirmation
Generate alarm if
additional activity
received.
Restart Alarm
Verification Cycle if
an Alarm
Verification point
activates.
Example: Total
Cycle time 80
seconds
☛
20 Seconds 60 Seconds
A# Duress Enable
Default: No
Selection:
Yes or No
Yes Enable Duress alarm for this area.
No Disable Duress alarm for this area.
Refer to
Duress Type
in Section 2.8 Miscellaneous on
page 31 for an explanation of duress.
The passcode you normally use for
duress is not valid in an area with A#
Duress Enable set to No.
Set this item as No for a particular area
and enter a valid duress passcode for
that area at the keypad to show NO
AUTHORITY.
To Next Page
Loading...
