D9412GV2/D7412GV2 | Program Entry Guide | 2.0 GV2MAIN EN | 15
Bosch Security Systems | 5/05 | F001U003636B
R# Backup Device
Default: Blank
Selection:
Blank, 1 to 4
1 Phone 1 or SDI Path 1 is this group’s
backup destination if the primary
destination fails.
2 Phone 2 or SDI Path 2 is this group’s
backup destination if the primary
destination fails.
3 Phone 3 or SDI Path 3 is this group’s
backup destination if the primary
destination fails.
4 Phone 4 or SDI Path 4 is this group’s
backup destination if the primary
destination fails.
Enter the number specifying the backup device. The
backup device is used when the primary device fails to
reach the programmed destination.
View Events?
Default: No
Selection:
Yes or No
Yes Access each routing group and
program individual events for this
route group only (D5200).
No Continue programming without
viewing individual groups.
The D5200 Programmer reveals the following sub-
prompts. Leaving
View Events?
as No allows the user
to ignore a large area of programming that might not
need to be changed.
Fire Reports
Selecting Yes enables a report to be sent when the
event occurs.
Table 8: Diagnostic Reports
Report Selections Report Description
R# Fire Alarm
Yes, No
Fire Event
R# Fire
Restore
(Alarm)
Yes, No
Fire restoral from
alarm
R# Fire
Missing
Yes, No
Missing Fire point
R# Fire
Trouble
Yes, No
Fire trouble
R# Fire
Supervis
Yes, No
Fire supervision
R# Fire
Restore
(T/M/S)
Yes, No
Fire restoral from
trouble, missing, or
bypass
R# Fire
Cancel
Yes, No
Canceled fire alarm
R# Fire Sup
Miss
Yes, No
Fire supervisory
missing
R# Fire Supv
Rest
∗
Yes, No
Restorals from Fire
Supervision
∗
This event is not reported when using BFSK format.
To Next Page
Loading...
