D9412GV2/D7412GV2 | Program Entry Guide | 6.0 GV2AUX EN | 122
Bosch Security Systems | 5/05 | F001U003636B
Figure 6: COMMAND 43 Flow Chart
1
2
9
10
11
3
9
10
6
11
11
4
7
5
8
1 - COMMAND 43
2 - Contact RPS?
3 - RPS via Phone?
4 - Seizes phone line and calls RPS
5 - Answer now?
6 - RPS by network?
7 - Begins RPS session over the network
8 - Seizes phone line and begins RPS session
9 - [PREV]
10 - [NEXT]
11 - [ENT]
RPS IP Address 1
Default: 0
Selection: 0 to 255
0 to 255
Enter the first three digits of the IP
address. Leading zeros are not
required.
This prompt and the next three prompts determine the
IP address for RPS.
An IP address has four fields. Each field has a range of
0 to 255. For example, an IP address is expressed as
110.227.64.190. (Refer to Figure 7.) The D5200
programmer divides the IP Address into four
programmable fields. Contact your network
administrator to determine the IP address to which the
RPS computer is connected.
Figure 7: RPS IP Address Prompts
Set RPS IP Address to 0 if Enable Ext
Modem is set to Yes.
RPS IP Address 2
Default: 0
Selection: 0 to 255
Refer to
RPS IP Address 1
.
RPS IP Address 3
Default: 0
Selection: 0 to 255
Refer to
RPS IP Address 1
.
RPS IP Address 4
Default: 0
Selection: 0 to 255
Refer to
RPS IP Address 1
.
110.227.64.190
RPS IP Address 1
RPS IP Address 2
RPS IP Address 3
RPS IP Address 4
To Next Page
Loading...
