Bosch D9412GV2 - Installing Modules and Relays; Connecting On-board Points and Keypads; Powering Up the System Sequence; Control Panel Programming Reference

D9412GV2/D7412GV2 | Program Entry Guide | 2.0 GV2MAIN EN | 19
Bosch Security Systems | 5/05 | F001U003636B
RPS Reports
Selecting Yes enables sending a report when the RPS
Passcode Event occurs.
RPS Access Fail can indicate a
wrong RPS passcode when
communicating with the control panel or a
valid RPS session was terminated by a
means other than a Good-bye or Reset-
bye command. Remote Reset indicates
a Reset-bye command issued from RPS,
Bad Call to RPS indicates the
control panel called RPS but was unable
to connect.
Table 15: RPS Reports
Report Selections Report Description
R# Log
Threshold
Yes, No
Event log threshold
reached
R# Log
Overflow
Yes, No
Log is full, old events
are overwritten
R# Para
Changed
Yes, No
RPS Parameter
Change Event
R# RPS OK
Yes, No
Successful RPS
Access Event
R# RPS Fail
Yes, No
Failed Access RPS
Event
R# Remote
Reset
Yes, No
Remote Reset Event
R# Program
OK
Yes, No
Successful Laptop
Access Event
R# Program
Fail
Yes, No
Failed Laptop Access
Event
Point Reports
Selecting Yes enables a report to be sent when the
event occurs.
Table 16: Point Reports
Report Selections Report
Description
R# Service Start
Yes, No
Reorts Service
Walk Test Start
Event
R# Service End
Yes, No
Service Walk
Test End Event
R# Fire Walk St
Yes, No
Fire Walk Start
Event
R# Fire Walk End
Yes, No
Fire Walk End
Event
R# Walk Test St
Yes, No
Walk Test Start
Event for Walk
Test and Invisible
Walk Test
R# Walk Test End
Yes, No
Walk Test End
Event for Walk
Test and Invisible
Walk Test
R# Extra Point
Yes, No
Extra Point Event
R# Send Point
Text
∗
Yes, No
Point Text
R# RF Low Bat
Yes, No
Low battery
conditions for RF
points
R# RF Low Bat
Res
Yes, No
Low battery
restoral
conditions for RF
points
∗
Point text is always transmitted when using
NetCom applications.