Bosch D9412GV2 - Enhanced Routing; Programming a Primary and Backup Destination; Programming a Duplicate Report

D9412GV2/D7412GV2 | Program Entry Guide | 2.0 GV2MAIN EN | 21
Bosch Security Systems | 5/05 | F001U003636B
2.4 Enhanced Routing
Enhanced routing allows the control panels to
determine if events are routed over standard telephone
lines or a local-area network (LAN) or wide-area
network (WAN). Sending events over a LAN or WAN
requires a network interface module (NIM), such as
the DX4020 or the D9133TTL-E.
Enhanced routing also enables and disables the ability
of the control panel to send events to a numeric pager.
If the installation does not require these
applications, skip this section.
With enhanced routing, whether you use standard
telephone lines or a NIM, you can program the control
panel to send full or partial groups of events to as
many as four different destinations. Routing includes:
• Choosing the most important destination
• Sending events to a single destination or to
multiple destinations
• Selecting a backup destination if events fail.
2.4.1 Programming a Primary and Backup
Destination
Each route number has an
R# Primary Device and
an
R# Backup Device . With enhanced
communications, the
R# Primary Device destination
can be either the phone number or the path number
for the SDI device, to which the route group first
attempts to send the event. If the
R# Primary Device
destination fails to connect to the central station
receiver after one or two attempts (refer to
RG# 1
Attempt
), the control panel attempts to connect with
the
R# Backup Device destination.
2.4.2 Programming a Duplicate Report
To send an event within a group to multiple groups,
program the event as Yes for each route number
available. For example, programming fire alarms for
Route Group 1 and Route Group 2 sends a fire alarm
report first to Route Group 1, followed by a duplicate
report to Route Group 2.
Section 2.4 Enhanced Routing on page 21 determines the
route groups and which destinations within the route
groups use network interface modules (NIMs) for
reporting purposes. A single NIM can send events to
as many as four different destinations.
For example, if you want to send events using Route
Group 1 over a LAN or WAN as your primary
destination, and you use a standard telephone line as
your backup destination, you must program the
following sections:
• Routing (Section 2.3 Routing on page 13)
1. Select Route Group 1
2. Program a 1 for Primary Destination
3. Program a 1 for Backup Destination
4. Enable all applicable events to be included in
Route Group 1.
• Phone (Section 2.1 Phone on page 9)
1. Select Phone 1.
2. Program Phone 1 with the applicable central
station receiver phone number.
• Enhanced Routing (Section 2.4 Enhanced Routing on
page 21)
1. Enter Yes for RG1 Primary SDI (Tells the
control panel to send the events to the
network interface module (NIM) using IP
Address 1)
2. Enter No for RG1 Backup SDI (Tells the
control panel to use the phone line to send
events if the primary destination fails after one
or two attempts)
Because you are using an SDI Path to send events, you
must also program the applicable items in Section 6.5
Programming Path Numbers and IP Addresses for Enhanced
Communications on page 127.
If you use a network interface module (NIM)
as a Primary Device in any of the route
groups, follow these programming rules:
• Assign IP Address 1 as the Primary
Device in Route Group 1.
• Assign IP Address 2 as the Primary
Device in Route Group 2.
• Assign IP Address 3 as the Primary
Device in Route Group 3.
• Assign IP Address 4 as the Primary
Device in Route Group 4.
The backup device in any route group can
use any phone number or IP address
number.