Bosch D9412GV2 - Access Control Functions; Access Ctl Level; Chg Display; Chg Time;Date

D9412GV2/D7412GV2 | Program Entry Guide | 2.0 GV2MAIN EN | 57
Bosch Security Systems | 5/05 | F001U003636B
Fire Test
Default: P
Selection:
Blank, E, or P
Function No. Function Name Alternate Keystroke
12 Fire Test [COMMAND][5][8]
Use this function to test 24-hour points in areas within
the scope of the keypad where the function is entered.
Controlled points,
P## Type 1 , 2, 3, cannot be tested
using the Fire Walk Test Mode.
Send Report
Default: P
Selection:
Blank, E, or P
Function No. Function Name Alternate Keystroke
13 Send Report [COMMAND][4][1]
or
[COMMAND][4][2]
Use this function to test the communication link
between the control panel and the central station
receiver(s). It can send a Test Report or a Status
Report to the phone numbers programmed in
Routing. The Test Report includes additional
information if
Expand Test Rpt is enabled in
Section 2.1 Phone on page 9.
2.11.3 Access Control Functions
Door Control
Default: P
Selection:
Blank, E, or P
Function No. Function Name Alternate Keystroke
14 Door Control [COMMAND][4][6]
#14 Door Control [COMMAND][4][6])
This top level display must be enabled for the user to
access the cycle door, unlock door, and secure door
functions (refer to Section 2.11.4 Authority Level Selections
on page 61). Use this item when programming door
control in your function menu.
Access Ctl Level
Default: P
Selection:
Blank, E, or P
Function No. Function Name Alternate Keystroke
37 Access Control
Levels
(Menu function only)
Shows the current on or off state of control levels 1
through 14, pertaining to Access Control Only, (
L##
Access Level
and L## Disarm Level ). The user can
toggle levels on and off and invalidate access control
levels during an extended period. This change only
affects the user’s token or cards; it does not affect
keypad Door Control functions.
Chg Display
Default: E
Selection:
Blank, E, or P
Function No. Function Name Alternate Keystroke
15 Change Display [COMMAND][4][9]
Use this function to select either a bright or dim
display with loud or soft keypad warning tones. You
can also choose the time and date display.
Chg Time/Date
Default: E
Selection:
Blank, E, or P
Function No. Function Name Alternate Keystroke
16 Change Time and
Date
[COMMAND][4][5]
Use this function to set the time and date in the control
panel.