D9412GV2/D7412GV2 | Program Entry Guide | 2.0 GV2MAIN EN | 49
Bosch Security Systems | 5/05 | F001U003636B
CC# Exit Tone
Default: Yes
Selection:
Yes or No
Yes This keypad sounds entry tones.
No This keypad does not sound entry
tones.
Determines whether keypads at this address setting
emit the Exit Now ### exit delay tone during the
delay arming of an area(s). Any keypad with a scope to
arm this area can initiate the exit tone sequence.
This prompt allows you to manage the tone by
keypad. Exit Tone can also be turned off when
programming
A# Exit Tone
in Area Parameters.
Assign two CCs to the same area so one
keypad emits the tone and another does
not.
CC# Arm Now Warn
Default: No
Selection:
Yes or No
Yes This keypad activates a tone and
displays PLEASE CLOSE NOW.
No This keypad does not activate the
tone or display PLEASE CLOSE
NOW.
Determines whether this keypad sounds a tone and
displays the PLEASE CLOSE NOW warning on the
keypad when a Closing Window activates, indicating
the area automatically arms soon.
CC# Close Door
Default: No
Selection:
Yes or No
Yes This keypad sounds a tone and
displays CLOSE DOOR #.
No This keypad does not sound the tone
or activate the display.
Determines whether this keypad sounds an audible
tone and displays the CLOSE DOOR # warning on the
keypad. This occurs when the door is physically held
open past the shunt time and the extend time has a
value greater than zero for the door assigned to this
area in
CC# Assign Door
. Refer to the D9210B
Program Entry Guide (P/N: 32207).
CC# EnhancCmdCtr
Default: No
Selection:
Yes or No
Yes This keypad is a D1260 Alpha V
Keypad.
No This keypad is not a D1260 Alpha V
Keypad.
When a D1260 Alpha V Keypad is installed at this
keypad address, this item must be set to Yes.
Reboot the system to enable an Alpha V
keypad.
To reboot the system, close and open the
reset switch, labeled “S1 RESET,” located
in the upper right corner of the control
panel.
To Next Page
Loading...
