To Next PageTo Next PageHow to fix Boyo GPS remote controller that doesn't work?
If the remote controller isn't operating your Boyo GPS, the remote control mode selector might not be set correctly. Switch the remote control mode selector according to the source you select.
Why doesn't my Boyo AVN700A screen dim with headlights?
If your Boyo GPS screen doesn't darken when the vehicle's lights are turned on, it's likely because the unit is set to auto dimmer. When set to auto dimmer, the unit isn't linked to the vehicle's light switch.
Why is the screen dark on my Boyo AVN700A?
If your Boyo GPS screen remains dark, it might be because the unit is in a location with a low temperature. Wait for a while after turning the power on to allow the temperature to rise. The normal brightness should return.
What to do if buttons don't work on Boyo GPS?
If nothing happens when you press the buttons on your Boyo GPS, the computer chip in the unit might not be functioning correctly. Try pressing the reset button on the unit.
Why is the sound distorted on my Boyo AVN700A?
If the sound quality from your Boyo GPS is poor or distorted, inspect the speaker wiring. One of the speaker wires might be pinched by a screw in the car. Also, ensure the speakers are wired correctly, with each output terminal connected to a different speaker. Reconnect the speaker wires if needed.
How to fix no sound on Boyo AVN700A?
If no sound is coming from your Boyo GPS or the volume is very low, check the fader and balance settings to ensure they aren't set entirely to one side. If they are, reset them. Also, verify that the input/output wires or wiring harness are correctly connected. Reconnect them properly if needed.
Why is the radio reception poor on my Boyo AVN700A?
If the AM/FM radio reception is poor with noise on your Boyo GPS, the TV antenna and the vehicle's radio antenna might be too close to each other. Try to separate the two antennas as much as possible. You can also try turning off the main unit.
Instructions for loading and replacing the remote control battery.
Procedures for cleaning the unit's panels, disc slot, and addressing lens fogging.
Identifies and describes the front panel components of the main unit.
Identifies and describes the left side components of the main unit.
Identifies and describes the rear panel components of the main unit.
Details the functions and layout of the remote control.
Explains how to select different operating modes on the unit.
Procedures for adjusting the audio volume using the unit's controls.
Instructions on how to mute the audio output of the unit.
Describes the Picture-in-Picture functionality for navigation.
Explains the Dual Zone audio feature.
How to adjust the angle of the LCD panel.
Procedure for ejecting or inserting CDs/DVDs.
Introduction to the NavMate navigation software and its features.
Legal terms and conditions for using the NavMate software.
Critical safety guidelines for using the NavMate navigation system.
Overview of the NavMate software, GPS, and map database functionality.
General steps and guidance for operating the NavMate software.
A brief guide to getting started with the NavMate navigation system.
Explores the features and operation of the NavMate software.
Details the functions of the buttons located on the display screen.
Describes the options available in the main menu of the navigation system.
Explains methods for selecting destinations using lists and spell mode.
Describes the buttons used in the spell mode for text input.
Functions available on the navigation system's map screen.
Guide on how to select a destination using the 'Go To...' feature.
Steps for selecting a destination by address or intersection.
Process for selecting a street name as part of destination entry.
How to find and select Points of Interest for navigation.
Using the on-screen keyboard to search for Points of Interest by name.
Functionality for routing to a saved home address.
Functionality for routing to a saved office address.
Options for saving and accessing favorite destinations.
Managing and viewing saved addresses in the address book.
Using the Trail Book feature to manage created routes.
Managing trips with multiple destinations in the Trip Book.
Navigating to a destination using latitude and longitude coordinates.
Accessing and navigating to previously visited destinations.
How to select a destination by interacting directly with the map.
Explains the process of calculating routes and receiving navigation guidance.
Displays a detailed view of intersections for better turn guidance.
Features and options for customizing the map view.
Information displayed about the vehicle's current position on the map.
Screen indication when approaching the destination.
How the system handles deviations from the planned route.
Options for adding or modifying saved favorite destinations.
Procedures for adding, editing, or deleting address book entries.
How to add or update the home address for navigation.
How to add or update the office address for navigation.
Managing trail entries, including adding, deleting, and editing.
Steps to create a new trail route.
Renaming saved trails for better organization.
How to remove trail entries from the system.
Managing trips, including adding and editing destinations within a trip.
Modifying or deleting destinations within an existing trip.
Creating and managing personalized Points of Interest categories.
Process for creating new categories for My POI feature.
Options for configuring map display settings, including POI visibility.
Modifying or deleting existing POI categories.
Setting up audio and distance alerts for approaching POIs.
Editing POI items by category, name, or phone number.
Accessing and configuring system preferences, display, and diagnostics.
Customizing route calculation, simulation, and guidance options.
Adjusting map orientation and display of status information.
User Interface configuration options.
Adjusting display settings for day and night driving conditions.
Configuring which POIs are displayed at different map scales.
Setting preferred units for distance display and announcements.
Procedures for setting the system's clock.
Selecting the system's display and voice guidance language.
Resetting the vehicle's position indicator on the map.
Accessing system diagnostics and information.
Performing diagnostics to check GPS reception and satellite status.
Viewing system software and map version details.
Using the trip computer to track driving data like speed and distance.
Viewing and navigating a pre-planned route.
Options for creating detours around current or upcoming roads.
Procedure to cancel the current navigation route.
Navigating using previously recorded trails.
Managing waypoints within a trail for navigation.
Overview of the NavUtil software and its components for managing navigation data.
Configuring the NavUtil software for device selection and language.
Using the utility to upload Point of Interest data.
Assigning POIs to categories within the POI Uploader.
Utility for uploading map and voice data to the navigation unit.
Choosing the geographical region for map data download.
Selecting the desired language for voice guidance.
Choosing the destination drive for map data download.
Steps involved in copying map data to the memory device.
Safely removing memory cards or disconnecting USB devices after data transfer.
Utility for backing up user-specific data from the navigation unit.
Utility for restoring backed-up user data to the navigation unit.
Interface overview for the radio function.
Explains the icons and their functions on the radio screen.
Basic steps for operating the radio function.
Lists radio frequencies for different geographical regions.
Details preset radio frequencies saved by country.
In-depth explanation of advanced radio functions like ASM and presets.
Interface overview for the satellite radio function.
Explains the icons used in the satellite radio interface.
Function to manually seek satellite radio channels.
Searching for satellite radio channels by category or station.
Displays information about the current satellite radio channel.
Basic steps for operating the satellite radio function.
Interface for controlling DVD playback.
Explains the icons used for DVD playback control.
Details the functions available through the pop-up menu during DVD playback.
Basic steps for playing DVDs on the unit.
Configuration options for DVD playback settings.
Interface for managing and playing iPod content.
Explains the icons used for controlling iPod playback.
Basic steps for connecting and operating an iPod.
Interface for AV input devices like camcorders.
Basic steps for connecting and using AV devices.
Interface for playing music files from USB/SD devices.
Icons for controlling music playback from USB/SD.
Interface for viewing photos from USB/SD devices.
Icons for controlling photo slideshows and rotations.
Interface for playing video files from USB/SD devices.
Icons for controlling video playback from USB/SD.
Basic steps for connecting and operating USB devices.
Basic steps for connecting and operating SD cards.
Interface for managing Bluetooth phone connections.
Icons related to Bluetooth phone functions.
Basic steps for connecting and using Bluetooth devices.
Process for pairing mobile phones with the unit via Bluetooth.
Advanced Bluetooth features like making and receiving calls.
Using the unit to play MP3 files from a paired mobile phone.
Interface for the rear view camera display.
Basic steps for activating and using the rear view camera.
Overview of the main setup menu options for system configuration.
Adjusting audio equalization settings.
Adjusting screen brightness, contrast, and sharpness.
Configuring speaker balance, fader, subwoofer, and center volume.
Settings for Bluetooth ring tones and navigation auto-change.
Settings for dual zone audio and system version information.
Configuring the system's time and date.
Step-by-step instructions for installing the unit.
Critical safety warnings related to electrical connections during installation.
Important cautionary notes for electrical connections and installation.
First part of the installation guide, covering unpacking and initial detachment.
Second part of the installation guide, focusing on securing the unit.
Instructions for inserting tools to begin disassembly.
Steps for unscrewing and detaching components during disassembly.
Diagram showing how to connect output cables for speakers and other components.
Definitions of technical terms used in the manual.
General troubleshooting tips for common unit malfunctions.
Troubleshooting issues related to CD, DVD, and VCD playback.
Troubleshooting for MP3 and WMA file playback problems.
Technical specifications for the DVD playback and monitor display.
Details on audio output configurations for different modes.
General specifications including power, dimensions, and operating conditions.
Specifications related to DVD playback capabilities.
General| Resolution | 800 x 480 |
|---|---|
| Bluetooth | Yes |
| Video Playback | Yes |
| Touch Screen | Yes |
| Rear View Camera Input | Yes |
| USB Port | Yes |
| SD Card Slot | Yes |
| Video Input | Yes |
| Backup Camera Input | Yes |
| Power Supply | 12V DC |
| Display Size | 7 inch |
| Navigation | Built-in GPS |
