Step 4. Remove Previously Used Material
If material is currently loaded, remove it.
¾ Open the label take-up spool handle.
¾ Open the nip rollers.
¾ Use a scissors to cut the label material between the liner and remaining labels. You may
leave about 8” of liner on the roll for future threading.
¾ Remove the used liner from unit and discard.
¾ Remove the remaining label roll from unit.
¾ Use tape to secure the end of the label roll. Be careful not to let the material spool unwind
from the core.
Wraptor™ User’s Guide 23
To Next Page
Loading...
