7.1.2 Cleaning the Wrapper Surface
1. Follow the steps in
Before You Begin on page 57 of this guide.
2. Open the front (clear) door on the Wraptor.
3. Dip a cotton swab in the isopropyl alcohol.
4. Using the moistened swab, clean the wrapper surface. Make sure the wrapper is free of dust, debris and
label adhesive build-up.
NOTE: Failure to remove adhesive build-up will cause
labels to jam on the wrapper surface.
5. Close the front door.
Figure 35. Clean Wrapper Surface
58 Wraptor™ User’s Guide
To Next Page
Loading...
