5.3.2 Run Tab Commands
The Run tab menu allows you to set the label to be wrapped (see
Figure 14). This menu displays the current
label, allows you to move to a different label and provides status information about the printing/wrapping
process.
Figure 14. Run Tab Menu
The following table describes the Run tab command buttons and status fields:
NOTE: The “go to” buttons are disabled if the print file only contains one label.
Button Description
>
Goes to the next label.
<
Goes to the previous label.
>>
Goes to the last label in the file.
<<
Goes to the first label in the file.
Goto…
Prompts for the label number to jump to.
Reset
Sets the Count (number of labels wrapped) to zero.
Queue
Open the job queue dialog.
Done
Press this button to close the current label file and
then open the next one in the queue.
Wrap
Shows the operating mode of the printer: Auto or
Manual. See
Config Tab Commands on page 42 for
details.
Count
Displays the number of labels wrapped.
Label
Number
Displays the position in the label file. If the print
file only contains one label this field displays
SINGLE.
File
The currently open label file.
Wraptor™ User’s Guide 35
To Next Page
Loading...
Need help?
General
