7.1.5 Cleaning the V-Roller
1. Follow the steps in
Before You Begin on page 57 of this guide.
2. Open the front (clear) door.
3. Dip a cotton swab in the isopropyl alcohol.
4. Using the moistened swab, clean all label adhesive from the serrated v-roller inside the wrapper with a
clean swab.
5. Close the front door.
Figure 38. Clean V-Rollers
7.1.6 Cleaning the Sensors
The wrapper contains five sensors that will require occasional cleaning. It is recommended that you clean
the sensors every 6 months to one year. To do this:
1. Follow the steps in
Before You Begin on page 57 of this guide.
2. Open the front and side doors of the unit.
3. Locate the label notch sensor using the graphic below as your guide.
4. Clean the label notch sensor with a clean swab dipped in isopropyl alcohol.
Figure 39. Clean Label Notch Sensor
Wraptor™ User’s Guide 61
To Next Page
Loading...
