Button Description
Default
Changes the Feed to Wire distance back to the
factory setting (i.e. zero).
Units
Changes the units of measure.
English
Sets Units to inches.
Metric
Sets Units to millimeters.
Cycles
Displays total number of print/wrap cycles on the
printer. The cycle value is not adjustable.
System Info
Displays software version information
(see Figure 20, below).
Wrap Count
Displays the number of times the Wraptor spins
around the wire.
Default
Sets the Wrap Count default.
OK
Saves changes and closes the dialog.
Cancel
Closes dialog without saving changes.
Figure 20. System Information
Wraptor™ User’s Guide 41
To Next Page
Loading...
Need help?
General
