Brady Wraptor - Invalid Name: Names Must Use (A-Z)

Wraptor™ User’s Guide 69
Error Message Possible Cause/Resolution
Invalid Name: Names Must use (A-Z)
or (a-z) or (0-9) or Hyphens.
Cause: Printer Name contains an invalid character.
Resolution: Enter a different printer name using valid
characters.
Firmware Memory Full
Cause: The Wraptor’s internal memory or
CompactFlash Memory Card is full.
Resolution: Use the File Management Utility to move
some print files out of the Wraptor’s internal memory
to make room for the new file.
Labels not present or bad Touch Cell
Cause: Wraptor cannot sense the loaded labels.
Resolution: Confirm that roll of labels is correctly
installed and the touch memory button is in the
material reader.
Print file has invalid command.
Cause: The printer firmware generates this message.
Resolution: The most likely cause is lost data. Try
printing the file again. If problem persists contact
Brady Technical Support.
Print Head is too hot
Cause: Print head is too hot.
Resolution: Open the print head and allow it to cool
down.
Print Head Open
Cause: The print head is open.
Resolution: Clean the tilt sensor. If that does not solve
the problem, check to see if there is a label jam. If so,
clear it.
Press the Online button on the Setup tab.
Remote Device is not receiving Data.
Please Check Remote Connection.
Cause: Wraptor software is in remote control and no
connection is available to an external device. Can also
occur if printer is turned off when in remote control.
Printer will start up in Remote Control mode later
when printer is turned back on.
Resolution: If a remote control type connection is
desired ensure cable and remote device are online. If
a remote connection is not desired machine will revert
automatically to local control on this error.
Serial Port Time Out
Cause: Wraptor had a problem sending a label to the
print/wrap mechanism.
Resolution: Reopen print file and try again.
Set focus on an input text box first.
Cause: User selected an Enter… button before
selecting a field in the dialog.
Resolution: Select a field and then select the Enter…
button.
Shuttle (slide) is not in dispense
position
Cause: Shuttle (slide) error
Resolution: Clean the wrapper home sensor.
Clean the shuttle home sensor.
If that does not solve the problem, check to see if there
is a label jam. If so, clear it.
Press the Online button on the Setup tab.