Brady Wraptor - Pixel Range Error

Wraptor™ User’s Guide 71
Error Message Possible Cause/Resolution
%d pixels is out of range. Upper limit
of 90 pixels is used.
Range.
Resolution: Reduce Adjustment to be within range
allowed.
The total Left Margin Offset setting of
%d pixels is out of range. Upper limit
of -90 pixels is used.
Cause: Remote Control Message. Parameter Out of
Range.
Resolution: Reduce Adjustment to be within range
allowed.
The total Peel to Feed setting of %d
pixels is out of range. Upper limit of
90 pixels is used.
Cause: Remote Control Message. Parameter Out of
Range.
Resolution: Reduce Adjustment to be within range
allowed.
The total Peel to Feed setting of %d
pixels is out of range. Upper limit of -
90 pixels is used.
Cause: Remote Control Message. Parameter Out of
Range.
Resolution: Reduce Adjustment to be within range
allowed.
The total Print Density setting of %d is
out of range. Upper limit of 10 is used.
Cause: Remote Control Message. Parameter Out of
Range.
Resolution: Reduce Adjustment to be within range
allowed.
The total Print Density setting of %d is
out of range. Upper limit of 10 is used.
Cause: Remote Control Message. Parameter Out of
Range.
Resolution: Reduce Adjustment to be within range
allowed.
The total Top Margin Offset setting of
%d pixels is out of range. Upper limit
of 90 pixels is used.
Cause: Remote Control Message. Parameter Out of
Range.
Resolution: Reduce Adjustment to be within range
allowed.
The total Top Margin Offset setting of
%d pixels is out of range. Upper limit
of -90 pixels is used.
Cause: Remote Control Message. Parameter Out of
Range.
Resolution: Reduce Adjustment to be within range
allowed.
This is an invalid print file.
Cause: Print file is corrupt or wrong version.
Resolution: Reprint the label file from the computer.
Call Brady Technical Support if this does not resolve
the problem.
Wrapper mechanism is not in home
position
Cause: Wrapper mechanism is not in home position.
Resolution: Clear wrapper jam.
Clean wrapper home sensor.
Press the Online button on the Setup tab.