Disassembly / Assembly SpaceStation
3
3- 24 SpaceStation, 1.0 gb
1.0
Housing Back Panel
1. Insert the housing back panel on the notches at the two con-
nector coverings into the housing and rotate the back panel
in its final position.
2. No screw is inserted in the third mounting hole (from the top)
on the right-hand side of the back panel. The hole must be
covered with a cover cap.
3.11 Checks after Repair
1. Check the device to ensure safe functionality of the unit (see
„Device Check“ ➨ S. 2 - 4).
2. Depending on the work carried out the specific steps of the
TSC must be performed (see „Technical Safety Check (TSC)“ ➨
S. 7 - 1).
3. The activities carried out must be recorded in the following
check list.
Abb.: 3 - 27
Legende zu Abb. 3 - 27:
ItemDesignation
1 Housing notch
2 Empty mounting hole
2
1
To Next Page
Loading...
