Broadcom NetXtreme Ethernet Adapter • Diagnostic User’s Guide
page 187
Broadcom Confidential and Proprietary
ERR_DRIVER 127 Unsupported driver version VX.XX (need bcm57diag v9.0.0 or
tg3d 3.66l or newer)
ERR_TXDMA_OVERFLOW 128 TxDMA Overflow
ERR_RXDMA_OVERFLOW 129 RxDMA Overflow
ERR_DRIVER_BAD_STATUS 130 Driver returned error status=XXXX on ioctl=X
ERR_INVALID_HANDLE 131 Invalid Handle
ERR_SOCKET 132 Socket open error XXXX
ERR_SIOCGIFINDEX 133 ioctl(): SIOCGIFINDEX failed
ERR_BIND 134 bind() failed:
ERR_SETSOCKOPT 135 setsockopt() failed:XXXX
ERR_FCNTL 136 fcntl() failed:XXXX
ERR_SEND 137 send() failed (cnt=XXXX): XXXX
ERR_RECEIVE 138 recvfrom() failed (cnt=XXXX): XXXX
ERR_FALSE_CARRIER 139 Error! False Carrier detected during the test
ERR_INV_OPT 140 Invalid Options
ERR_INV_DEV 141 Found Rv = XXXX, Expected Rv = XXXX due to -ckdev
value
ERR_IRQ 142 Invalid IRQ XX
ERR_TIMEOUT 143 Timeout
ERR_PKT_DATA 144 Packet data error at offset XXXX, expected XX but recevied
XX
ERR_MAC_ZERO 145 Zero Mac Address in Mac Register
ERR_MAC_MIS_REG 146 Mac Address MisMatch: Got XX-XX-XX-XX-XX-XX.
ERR_CPU_ACC 147 Rx | Tx CPU failed on XXXX bit access to address XXXX
ERR_CPU_MEM 148 Rx | Tx CPU failed on memory pattern XXXX at address XXXX
ERR_CPU_INSTR 149 Rx | Tx CPU Instruction test failed
ERR_BUS_LINK 150 PCI-E Bus Link Error
ERR_ASF_FILE_VER 151 ASF File versions Error
ERR_ASF_VS_DEV 152 ASF VS Device Error
ERR_MISMATCHED_DEVICEID_1 153 bootcode Image file belongs to unknown family, does not
match with board XXXX
ERR_MISMATCHED_DEVICEID_2 154 bootcode Image file belongs to XXXX family, does not match
with unknown board
ERR_CPU_FETCH 155 CPU Fetch Test Error: Breakpoint reads XXXX
ERR_UMPLB 156 UMP loopback failed, Total Good packet XXXX
ERR_UMPCTRL 157 Error: UMPCtrl 0x5F0 = XXXX
ERR_REG_TABLE 158 Error: Unable to create Reg Table
ERR_FW_IMAGE_SIZE 159 Error: Firmware image size (XXXX) larger than NVRAM size
(XXXX)
ERR_MISS_PXE 160 Error: PXE firmware cannot be found in NVRAM
ERR_MISS_ASF 161 Error: ASF firmware cannot be found in NVRAM
ERR_NVRAM_DIR 162 Error: NVRAM Directory
ERR_MISS_UMP 163 Error: UMP firmware cannot be found in NVRAM
ERR_CPU_MEM2 164 Rx | Tx CPU memory error @ XXXX, expected XXXX but got XXXX
ERR_SERIAL1 165 PCIE Serial Device Number Capability Not Found.
ERR_SERIAL2 166 PCIE Serial Device Number Match Failure.
ERR_POWER1 167 PCIE Power Budget Capability Not Found.
ERR_POWER2 168 PCIE Power Budget Error (ad=XXXX, saw=XXXX, exp=XXXX).
ERR_UMP_VS_DEV 169 UMP VS Device Error
ERR_HM_BR_LANES 170 M Bridge Lanes Error: XXXX PCI-E lanes are actually linked
and running, expected XXXX.
ERR_BRIDGE 171 Invalid bridge.
ERR_NO_LINK10 172 No good link at 10 Mbits/s! Check Loopback plug
ERR_NO_LINK100 173 No good link at 100 Mbits/s! Check Loopback plug
ERR_NO_LINK1000 174 No good link at 1000 Mbits/s! Check Loopback plug
ERR_DMA_SHASTA 175 Failed! Saw=XXXX @ XXXX, Exp=XXXX from XXXX
ERR_SECFG_CONT 176 SECFG Config Error. Line XXXX
ERR_SECFG_INVALID 177 Invalid Argument in SECFG Config File at Line XXXX
ERR_NV_SELFBOOT 178 NVRAM is SELFBOOT
ERR_PART_NUM 179 Error Part Number Check Failed
ERR_UMPECHO 180 UMP Echo - Debug Mode
ERR_IMAGE_CHECKSUM 181 Firmware image checksum error
ERR_INVALID_SMB 182 Invalid SMB Address
ERR_LOM_CFG 183 LOM CONF Bit mismatch in Reg 178 and Reg 7C04
ERR_ISCSI_PGM 184 iSCSI Programming Error
ERR_BAD_CHIP_REV 185 Invalid Chip Rev.
ERR_NO_CPU 186 Device has no internal CPU
ERR_BAD_PARITY_VALUE 187 Invalid Parity.
ERR_BAD_VPD_CHKSUM 188 Invalid VPD Checksum
ERR_ESWITCH_CTRL_TO 189 Halting E Switch Ctrl time out. XXXX
ERR_ESWITCH_EVENT 190 ESWITCH event not set. XXXX
ERR_ESWITCH_TO 191 E Switch time out. XXXX
ERR_ESWITCH_ARBIT_TO 192 Halting E Switch Ctrl Arbitor time out. XXXX
ERR_ESWITCH_INTR 193 ESWITCH interrupt not set. XXXX
ERR_ESWITCH_STATUS 194 ESWITCH status word not set. XXXX
To Next Page
Loading...
Need help?
General
