Broadcom NetXtreme Ethernet Adapter • Diagnostic User’s Guide
page 188
Broadcom Confidential and Proprietary
ERR_SADB_ENTRY 195 SADB Entry error at SA Indx XXXX with pattern <string>
ERR_SADB_CORRUPT 196 SADB Data corrupted: Got XXXX at SADB index XXXX word index
XXXX. Expected = XXXX
ERR_SADB_DEL_ALL 197 SADB delete all error
ERR_SADB_DEL 198 SADB delete SA index XXXX error
ERR_SADB_INTR 199 SADB interrupt not set. <string> index XXXX
ERR_SADB_ENTRY_TEST 200 SADB Entry Test error at SA Indx XXXX
ERR_SHA1_NOT_SUPPORTED 201 SHA1 not supported
ERR_DIR_CHECKSUM, 202 Directory Checksum Error
ERR_APE_REGISTER_RANGE, 203 Invalid APE register range
ERR_APE_MUTEX_RELEASE, 204 Can not release APE Mutex Grant register
ERR_APE_MUTEX_REQUEST_GRANT 205 APE Mutex register was not granted (Mutex registers
0xXXXX=XXXX; 0xXXXX=XXXX).
ERR_APE_TIMER_RESET 206 APE Timer reset value error, XXXX.
ERR_APE_TIMER_RUN 207 APE Timer counting error, XXXX.
ERR_APECPU_LOAD 208 APE firmware load error: XXXX
ERR_APECPU_TIMEOUT 209 APE CPU test timed out: XXXX
ERR_APECPU_MEM 210 APE CPU Memory Test error: XXXX
ERR_APECPU_ETH 211 APE CPU Ethernet Test error: XXXX
ERR_APECPU_SMB 212 APE CPU SMBus Test error: XXXX
ERR_APECPU_GPIO 213 APE CPU GPIO Test error: XXXX
ERR_APECPU_EVENT 214 APE CPU Event Test error: XXXX
ERR_APECPU_MUTEX 215 APE CPU Mutex Test error: XXXX
ERR_APECPU_TIMER 216 APE CPU Timer Test error: XXXX
ERR_APECPU_GRC 217 APE CPU GRC Test error: XXXX
ERR_POST_100_LB 218 Tx/Rx Lines Have A Short/Open
ERR_DATA_TX_MISSING_IPSEC 219 Requested Tx of XXXX IPSEC Pkt(s) with Cipher <string>.
Only XXXX transmitted
ERR_DATA_RX_MISSING_IPSEC 220 Expected Rx of XXXX IPSEC Pkt(s) with Cipher <string>.
Only XXXX received
ERR_RX_HW_CRYPTO_DONE_CNT 221 Got HW_CRYPTO_DONE_CNT = XXXX, Expected XXXX
ERR_USER_BLOCK_NOT_AVAILABLE 222 User block not available
ERR_CPU_MUTEX_ERROR 223 Rx | Tx CPU test APE Mutex error, test XXXX
ERR_CPU_REG_ERROR 224 Rx | Tx CPU test APE reg error, test XXXX
ERR_CPU_BIN_FILE_MISMATCH 225 Soledad Rev B0 and up should use cpusd.bin version 4.0 or
up.
ERR_USB_NOT_DETECTED 226 USB device was not detected. Please check cable
connection.
ERR_USB_DATA_ERROR 227 USB device error during data transfer.
ERR_SELFBOOTII_BAD_ECC, 228 SelfbootII CPD #XXXX ECC got corrupted.
ERR_SELFBOOTII_BAD_CPD, 229 SelfbootII CPD #XXXX got corrupted.
ERR_SELFBOOTII_FULL, 230 OTP is full.
ERR_SELFBOOTII_EMPTY, 231 OTP is empty.
ERR_SELFBOOTII_OTP_CORRUPTED 232 Dismatched when compared to file <filename>
To Next Page
Loading...
Need help?
General
