6-7
Confidential
(6) Drag the firmware (LZ·········.blf) in the same folder and drop it onto the icon of the
applicable model in FILEDG32.
The files in the firmware are sent to the printer so that they are started to write into the
flash ROM automatically. After finishing receiving the files, the printer starts to rewrite the
firmware.
The “Loading XXX” message appears on the LCD panel while receiving the file.
(7) The address messages appear on the LCD panel while the firmware being written.
Then, be sure not to disconnect the USB cable or to turn off the power supply of the PC
before all LEDs are ON to indicate that this firmware rewriting is done. The
“….Complete….” message appears on the LCD panel when the firmware rewriting is
done properly.
(8) Turn the power supply of the printer off.
1.2 Setting the default paper size
(1) Open the “hl5300” folder and double-click the FILEDG32 icon to start. Select the
applicable printer and click it. (Make sure that there is the icon of the connected printer
and that no error occurs.)
(2) Drag “s5300” in the same folder and drop it onto the icon of the applicable model in
FILEDG32. When the Status LED (LED model) or the Data LED (LCD model) of the
printer lights up for an instant and goes off immediately after dropping it, the setting is
completed. Then, set the serial number following the steps described in the next
section.
Refer to the following step to set the serial number.
Note;
• If the error related to the BLF file or the printer occurs, the red backlight of the LCD
panel lights up and the error message appears.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
