4-17
Confidential
6.1 Check head nozzles (Maintenance mode 09)
Check head nozzles, referring to “2.3 Check head nozzles (Maintenance mode 09)”.
6.2 Adjustment of software correction for inclination/corrugation/ruled lines
(Maintenance mode 65)
Refer to Chapter 5, Section 1.3.21 "Adjustment of Software Correction for Inclination/
Corrugation/Ruled Lines (Maintenance mode 65)."
6.3 Updating of paper feeding correction values (Maintenance mode 58)
Refer to Chapter 5, Section 1.3.17 "Updating of Paper Feeding Correction Values
(Maintenance mode 58)."
6.4 Adjustment of margins in borderless printing (Maintenance mode 66)
Refer to Chapter 5, Section 1.3.22 "Adjustment of Margins in Borderless Printing
(Maintenance mode 66)."
6.5 Check printing
Under “1.16 Check scanning and printing” in this chapter, refer to and take steps for
"Updating of paper feeding correction values", "Adjustment of software correction for
inclination/corrugation/ruled lines" and "Adjustment of margins in borderless printing".
To Next Page
Loading...
