113
Type 8692, 8693
english
Start-up, operation
process controller Type 8693
If the P.CONTROL auxiliary function is active for the process controller Type 8693, the following auxiliary functions differ from
those described for the position controller Type 8692 (highlighted in Fig. 20):
CUTOFF•
SECURITY•
SIG.ERROR•
OUTPUT•
CAL. USER•
4.1.1 Including auxiliary functions in the main menu
Press the arrow keys to select the → ADD.FUNCTION menu option in the main menu and press the right selection key
(ENTER) to enter the submenu.
Press the arrow keys to select the required auxiliary function. →
Press the selection key on the right (ENTER) to mark the auxiliary function with a cross (x). →
All marked functions are transferred to the main menu when the selection key on the left (EXIT) is pressed. →
In the main menu input the parameters of the auxiliary functions. →
4.1.2 Removing auxiliary functions from the main menu
If a function is removed from the main menu, the settings implemented previously under this function become invalid
again.
Press the arrow keys to select the
→ ADD.FUNCTION menu option in the main menu.
Enter the submenu by pressing the selection key on the right (ENTER). →
Press the arrow keys to select an auxiliary function indicated with a cross (x). →
Press the selection key on the right (ENTER) to remove the cross (x). →
After pressing the selection key on the left (EXIT), the auxiliary function is deactivated and removed from the main menu. →
A precise description on the operation of the auxiliary functions can be found in the chapters entitled "Start-up,
operation of the position controller Type 8692" - "Specifying the basic settings" and in "Configuring the auxiliary
functions".
To Next Page
Loading...
